Nechajte si poradiť vašimi ušami

Ochrana osobných údajov     © 2025 Zalan Schuster

ZS Acoustics Products ZS Acoustics Termékek ZS Acoustics Produkty

Line Audio Cables:

ZS Acoustics Baritone

ultra-thin ribbon (foil) RCA, XLR line audio cable



The foil (also known as ribbon) as a conductor has excellent signal transfer properties compared to any other conductor geometry.


They are sonically neutral and with a balanced characteristic. They are transparent with precise localization of musical instruments and vocals with clear mid-highs with high resolution. The bass is balanced and energetic, less boomy than conventional cables, although we feel that the bass goes deeper. With these properties, the foil, ribbon line audio cables ZS Acoustics Baritone are among the best cables currently on the market.


The Baritone cable construction utilizes a phenomenon called skin effect.

Skin effect or surface (electric) phenomenon results in a higher concentration of electric current on the surface of the conductor compared to other parts of the conductor. https://en.wikipedia.org/wiki/Skin_effect

This effect becomes more pronounced as the frequency of the passing current increases. We counteract this effect by increasing the conductor's surface area compared to the inside.

Higher frequencies propagate faster at the edges and on the surface, while lower frequencies propagate slower at the center of the conductor. As a result, a time delay occurs between low and high tones at the output end of the conductor.

The design objective was to reduce signal transmission error caused by this time delay in the conductor.

This is where the usefulness of the foil conductor concept is revealed, as its surface-to-volume ratio is significantly higher than that of a thick conductor. Low frequencies are also forced to propagate more on the surface, reducing the time delay between low and high frequencies. Therefore, the foil conductor is thin but must be wide.

RCA has a single-point ground. This means that only one channel is connected to ground. With mono power blocks, both channels must be connected to ground. There is no ground connection with XLR. The result is an even quieter background, greater resolution and sound space.

For high frequencies that propagate on the surface, the quality of the conductor's surface and the material of its insulation are very important. That's why the Baritone cable is manufactured with a highly reflective conductor surface where surface unevenness is minimized. This minimizes distortion caused by material granularity, which exists in any metallic conductor, and nearly eliminates sound roughness.

If the surface finish is rough, impedance mismatches are likely to occur, particularly at higher frequencies. These impedance mismatches cause signal loss and compromise the integrity of the audio signal. Hence, maintaining an optimal surface finish for conductors is crucial.


Non-bleached cotton is used for insulation, which has a dielectric constant of only 1.3. Let's compare this with PVC insulation, which is most commonly used in cables, with a dielectric constant of 4, causing a greater impact on the signal in the conductor.


In expensive audio cables, the best synthetic material PTFE PolyTetraFluoroEthylene with a dielectric constant of 2.1 is used. Cotton surpasses this material. The lower the dielectric constant, the better it is for the audio signal, the less it distorts and changes it. The texture of cotton weave further minimizes its impact on the cable because cotton touches the conductor over a smaller area. Cotton also plays an important role as a damper in reducing unnecessary vibrations that affect the resulting sound, so-called microphonics.


At the end of the cable are jewelry-like non magnetic connectors with high-quality pure gold, which maintain the best appearance of the product for a long time.


The plugs are in direct contact with the conductor, and the joint is filled with the best silver solder. The plug and joint are embedded in dry wood, which is a good insulator with a dielectric constant of 1.4 which is very low value.


See also Cable Elevators


Technical data:


• separate directional ultra-thin ribbon (foil) conductor for one polarity


• insulating material cotton


• single-point grounding for RCA, no connection to ground for XLR


• high-gloss, smooth conductor surface for better signal fidelity


• jewelry-like non magnetic connectors with high-quality pure gold, which maintain the best

 appearance of the product for a long time


• the conductor material is extremely pure oxygen-free OFC rolled copper, which has a special

 directional crystal lattice structure.


Home demo


Try ZS Acoustics Baritone Speaker Cable for free. Contact us


Watch the video about Skin Effect where you can also see the phase shift



Baritone RCA line audio cables:

Please specify when ordering if the cable is intended for monoblock power amplifiers.


€699 /pair      Price version: 0.75 m

€759 /pair      Price version: 1 m

€949 /pair      Price version: 1.5 m

€1139 /pair    Price version: 2 m

€1499 /pair    Price version: 3 m

€2289 /pair    Price version: 4 m



Baritone XLR line audio cables:


€1040 /pair    Price version: 0.75 m

€1365 /pair    Price version: 1 m

€1690 /pair    Price version: 1.5 m

€2015 /pair    Price version: 2 m

€2665 /pair    Price version: 3 m

€3315 /pair    Price version: 4 m


warranty: 2 years

zs_acoustics_baritone_xlr_detail.jpg

We use natural insulation material, cotton

ZS Acoustics Baritone rca,xlr Hun ZS Acoustics Baritone rca,xlr ZS Acoustics Cable Elevators
ZS Acoustics Products
zs_acoustics baritone_rca.jpg zs_acoustics baritone_rca_detail.jpg zs_acoustics baritone_xlr.jpg zs_acoustics baritone_audio_cable_box_close.jpg zs_acoustics baritone_xlr_box_open.jpg